Jetta SportWagen L4-2.0L Turbo (CCTA) (2009)
‹› One bolt - arrow - is located outside of bolting flange.
-
Secure input shaft by inserting thrust tube (VW 455) over input shaft onto clutch housing.
-
Then tension separating tool - A -, e.g. (Kukko 17/0) tightly behind input shaft splines.
During this, back side of separating tool must contact thrust tube free of play.
-
Knock rubber through in center of sealing cap - C - using a screwdriver.
-
Remove cap from transmission housing.