Jetta SportWagen L5-2.5L (CBUA) (2009)
Rear Door Panel: Service and Repair
Rear Door Trim
NOTE: Removal and installation of trim is described for right rear door. The same instructions apply for removal and installation of trim for the left
rear door.
Removing
-
Switch off ignition.
-
Pry upper section of grip shell - 1 - out of pull handle in door trim using wedge 3409.
-
Remove bolts - 2 - and - 3 - (1.5 Nm).
-
Remove bolt - 4 - (2 Nm).
-
Disengage door trim from mounts in lower area using disassembly pliers 3392.
-
Disengage door trim from mounts on the sides using disassembly pliers 3392.
-
Pull door trim vertically upward out of window shaft seal.
-
Depending on vehicle equipment, disconnect wiring harnesses from door trim.
-
Detach release - 5 - from inside door release mechanism - 6 -.