Jetta SportWagen L5-2.5L (CBUA) (2009)
-
Remove the brake lines - 1 - from the master cylinder, seal brake lines using sealing plugs from sealing plug repair kit (1H0 698 311 A).
-
Remove nuts - 2 - for the master cylinder.
-
If present, remove the heat shield.
-
Carefully remove the master cylinder out of the brake booster.
Installing
-
Installation is performed in the reverse sequence.
Observe the following points when installing:
-
When installing the master cylinder to the brake booster, make sure that the push rod is correctly located in the master cylinder.
-
Connect the battery..
-
Bleed the brake system. Refer to --> [ Brake System, Bleeding ] See: Brake Bleeding/Service and Repair/Brake System, Bleeding
Tightening Specifications