Jetta SportWagen L5-2.5L (CBUA) (2009)
/Page-330002.png)
-
Remove bolts - 1 -.
-
Pry off the upper oil pan from the cylinder block at the designated points using a suitable screwdriver - A -.
B Bearing cap 6 for the crankshaft
C Bearing cap 1 for the crankshaft
Installing
CAUTION!
To prevent injuries from shavings, wear protective goggles and protective clothing.
-
Remove the remainder of sealant from the upper oil pan and cylinder block e.g. using a rotating plastic brush.
CAUTION!
Make sure that no sealant residue enters the engine.
-
Clean the sealing surfaces so they are completely free of any oil or grease.
-
Cut the tube nozzle at the front marking (diameter of nozzle approximately 1 mm).
