Jetta SportWagen L5-2.5L (CBUA) (2009)
Crankshaft Main Bearing Seal: Service and Repair
Crankshaft Seal, Transmission Side
Crankshaft Seal, Transmission Side
Special tools, testers and auxiliary items required
‹› Assembly tool (T10122)
‹› Pulling hook (T20143)
Removing
-
Remove the transmission.
-
Lock the crankshaft. Refer to --> [ Crankshaft, Locking ] See: Cylinder Block Assembly/Crankshaft/Service and Repair/Procedures/Crankshaft,
Locking.
-
Remove the flywheel or drive plate and remove the sensor wheel for the Engine Speed (RPM) sensor from the crankshaft.
-
Remove the seal using the (T20143/2).
Do not damage the crankshaft sealing surface when doing this.
Installing
‹› Do not additionally oil or grease the sealing lip of the oil seal!
-
Clean the sealing surfaces. They must be free of oil and grease.
-
Before installing, remove any oil remaining on the end of the crankshaft with a clean cloth.
-
Insert the (T10122/1) onto the (T10122/2) and slide the seal - A - onto the (T10122/1).