Jetta SportWagen L5-2.5L (CBUA) (2009)
-
Switch the ignition on.
-
Using a multimeter, check the Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G465) electrical harness connector
terminals 3 to 4 for voltage.
Specified value: 0.400 to 0.500 Volts
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G465).
If the specified value was not obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to --> [ Motronic Engine Control Module, Replacing ] .
-
Using a multimeter, check the Oxygen Sensor (O2S) 2 Behind Three Way Catalytic Converter (TWC) (G465) electrical harness connector
terminals to the Engine Control Module (ECM) (J623) electrical harness connector T121 terminals for resistance.