Jetta SportWagen L5-2.5L (CBUA) (2009)
Transmission Position Switch/Sensor: Testing and Inspection
Selector Lever Voltage Supply, Checking
Special tools, testers and auxiliary items required
‹› multimeter.
‹› Wiring diagram.
Test requirements
‹› The Direct Shift Gearbox (DSG) Mechatronic (J743) fuses OK.
‹› Battery voltage at least 12.5 volts.
‹› All electrical consumers such as, lights and rear window defroster, switched off.
‹› Selector lever in "P".
‹› A/C switched off.
‹› Ground (GND) connections between engine/transmission/chassis OK.
‹› Ignition switched off.
Test procedure
-
Perform a preliminary check to verify the customers complaint. Refer to --> [ Preliminary Check ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Preliminary Check
Start diagnosis
-
Remove the selector mechanism, far enough to gain access to the Selector Lever (E313) electrical harness connector - A -.
-
Disconnect the Selector Lever (E313) electrical harness connector - A -.