Jetta SportWagen L5-2.5L (CBUA) (2009)
Clutch Switch: Service and Repair
Clutch Position Sensor
Special tools, testers and auxiliary items required
‹› Hose Clamps Up to 25 mm dia. (3094)
Removing
-
First check whether a coded radio is installed. In this case, find out anti-theft coding.
-
Disconnect battery Ground (GND) cable with ignition switched off.
-
Remove entire air filter housing, if it is located in the vicinity of the battery.
-
Remove battery and battery carrier
If a hose/line assembly - 1 - with a round component is installed directly below the master cylinder, hose/line assembly must be removed.
‹› While performing the following work, make sure that no brake fluid comes into contact with longitudinal member or with transmission. If this
happens, these areas must be cleaned thoroughly.
-
Use Hose Clamps Up to 25 mm dia. (3094) to clamp supply hose to master cylinder.