Jetta Wagon L4-1.8L Turbo (AWP) (2005)
Knock Sensor: Testing and Inspection
With Generic Scan Tool
Knock Sensors, Checking
NOTE:
-
Contact surfaces between knock sensor and cylinder block must be free of corrosion, dirt and grease.
-
For the Knock Sensors to function properly, it is important for tightening torque to be exactly 20 Nm.
-
Use only gold-plated terminals when servicing terminals in harness connector of knock sensors.
Recommended special tools and equipment
-
V.A.G1526 multimeter or V.A.G1715 multimeter
-
V.A.G1594 connector test kit
-
Wiring diagram
Test requirements
-
Knock sensor securing bolt tightened to 20 Nm.
-
On Board Diagnostic (OBD) must have recognized a malfunction at one or both of the Knock Sensors (KS).
-
Ignition switched off.
Checking resistance values of knock sensors
Vehicles with engine code AWD
-
Disconnect 3-pin harness connector for Knock Sensor (KS) 1 -G61- (-1-).
-
Measure resistance between terminals 1 + 2, 1 + 3, and 2 + 3 at connectors to knock sensors.
Specified value: Infinite Ohms
-
Disconnect the 3-pin harness connector for Knock Sensor (KS) 2 -G66- (-1-).
-
Measure resistance between terminals 1 + 2, 1 + 3, and 2 + 3 at connectors to knock sensors.
Specified value: Infinite Ohms
If specified value is not obtained:
-
Replace respective knock sensor:
-
Knock Sensor (KS) 1 -G61-
-
Knock Sensor (KS) 2 -G66-
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control