Jetta Wagon L4-1.8L Turbo (AWP) (2005)
Shifter A/T: Service and Repair
Selector Lever Handle, Removing and Installing
Selector lever handle, removing and installing, 09A, 5 Spd. A/T
There are various handles which are removed and installed in different ways.
Before starting disassembly work:
-
Slide sleeve on selector lever downward and check color of plastic part in handle (arrow).
Red-brown plastic: This handle can replace handle with black plastic part.
Removing
-
Pull upward on handle but do not press button.
Note: If button is inadvertently pressed, use compressed air and carefully blow button outward again.
-
Ensure always that button is projecting at lease 10 mm -a- when installing.
-
Slowly pull button by hand past perceptible pressure point so that it will not fall back again.
-
Push handle onto selector lever to install
Removing handle with black plastic part
-
Shift selector lever to position "R".