Jetta Wagon L4-2.0L (BEV) (2005)
-
Swing wheel with suspension strut outward and support e.g. with a piece of wood - 1 -.
-
Remove bolts - 1 - and - 2 - and remove pendulum support.
-
Remove bolt - 5 - for steering gear.
-
Remove stabilizer bar link nut - 7 - TDI engines, remove bolts - 6 - for exhaust system.
-
Place engine/transmission jack VAG 1383 A with VAG 1359/2 under subframe.
-
Remove bolts - 3 - and - 4 - for subframe.
-
Lower subframe using engine/transmission jack VAG 1383 A.
Installing
Before inserting bolts for subframe, position steering gear on subframe and insert bolts for steering gear
The threaded sleeve - 1 - must seat in subframe hole.
Further installation in reverse order
After installing check position of steering wheel during a test drive.
If steering wheel is not in straight ahead position the front axle alignment must be checked!