New Beetle
Assembly overview |
1 - | Lid |
q | Removing: |
– | Remove wiring/lines for windscreen washer system → Item and remove washer jets or separate at hinge |
– | Disconnect gas strut → Item from bonnet |
– | Unscrew bolts → Item and take off bonnet |
q | Adjusting → Chapter |
q | 01.00 a modified bonnet is used |
2 - | Filler piece |
3 - | Gas strut |
q | Removing and installing, as for rear lid → Chapter |
q | Releasing gas → Chapter |
4 - | Ball stud |
q | 21 Nm |
5 - | Plenum chamber seal |
q | Pushed onto flange |
6 - | Clip |
7 - | Cd seal |
8 - | Hinge |
9 - | Bolt/screw |
q | 23 Nm |
10 - | Spray jet hose |
q | Removing → Electrical system; Rep. Gr.92 |
11 - | Adjustment buffer |
q | Can be screwed in and out to adjust the bonnet height in relation to the wings |
q | Various locations on bonnet depending on type of engine and version of bonnet |