Removing and installing rear lid lock for New Beetle Cabriolet
Removing and installing lid lock (Cabriolet) |
1 - | Lock |
q | Removing: |
– | Remove lid trim → General body repairs, interior; Rep. Gr.70 |
– | Separate connector from lock |
– | Unclip operating rod → Item, remove bolts → Item and take lock off lid |
2 - | Bolt/screw |
q | 23 Nm |
3 - | Connector |
4 - | Operating rod |
5 - | Rear lid |
6 - | Pull rod (USA) |
7 - | Lever (USA) |
8 - | VW emblem |
q | Upper part for access to lock cylinder |
q | Bolted to carrier → Item |
q | Removing: |
– | Remove carrier with lock cylinder → Chapter |
9 - | Carrier with lock cylinder |
q | With lock cylinder and microswitch |
q | Removing and installing → Chapter |
10 - | Bolt/screw |
q | 3 Nm |
q | Qty. 3 |
11 - | Bolt/screw |
q | 5 Nm |
q | Qty. 3 |
12 - | Microswitch |
13 - | Securing clip |
14 - | Bolt/screw |
15 - | Support plate |
q | With remote release motor |
q | Removing and installing → Chapter |
16 - | Remote release motor |
17 - | Connector |
18 - | Bolt/screw |
q | 23 Nm |
19 - | Lock plate |
q | Adjusting - within oversized holes |
q | Removing: |
– | Remove load sill trim → General body repairs, interior; Rep. Gr.70 |
– | Remove bolts → Item |
20 - | Spring (USA) |
21 - | Nut (USA) |
22 - | Shaft (USA) |