| –
| Raise door window to top position until the clamps are accessible in the assembly openings -1-. |
| –
| Loosen clamps -2- and -3- and nut -4-. |
| –
| Press side window into front window guide -arrow-. |
| –
| Adjust distance -a- to 65 mm. |
Note | Apply locking compound to bolts/screws -2- and -3- before tightening (only for not microencapsulated bolts). |
| –
| Tighten clamp -3-, torque setting: 8 Nm. |
| –
| Lower door window completely and raise door window to top position again until the clamp -2- is accessible. |
Note | Lowering door window completely and raising it again completely is ineffective when attempting to obtain parallelism between the door window regulator guides. |
| –
| Tighten clamp -2-, torque setting: 8 Nm. |
| –
| Tighten nut -4-, torque setting: 8 Nm. |
| –
| Verify that distance -a- equals 65 mm. If necessary adjust again. |
| –
| Install front door trim. |
WARNING | Force limitation intervention will be activated if adjustment in X axis is incorrect. |
|
|
|
|
