volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting height of trim B > < Adjusting gap/shut lines C and D

New Beetle

Adjusting height of trim A
Adjusting height of trim A
–  Remove side panel trim → Chapter.
   
–  Disconnect push rod -1- from lever -4-.
–  Remove nut -2-.
–  Turn ball socket -3-.
The length of the push rod is adjusted by turning the ball socket -3- on the push rod. This in turn adjusts the height of the trim.
–  Tighten nut -2-.
–  Reconnect push rod -1- from lever -4-.
  M70-0167
–  Check trim height -A- and adjust again, if necessary.
–  Install side trim panel → Chapter.
  M70-0163

Adjusting height of trim B > < Adjusting gap/shut lines C and D