Volkswagen Workshop Service and Repair Manuals > New Beetle > Body | General body repairs, interior | Trim, noise insulation | Pillar and side trims (Cabriolet) | Adjusting large and small trim

Adjusting height of trim B

–	Remove side panel trim → Chapter.

–	Remove main frame for flap modules → Chapter and → Chapter. -12-

–	Remove screws -1-.

–	The height and tilt angle in areas -A-, -B- and -C- are adjusted by screwing screws -1-, -2- and -3- in or out.

1 = A

2 = B

3 = C

–	Tighten screws -1- (3 Nm).

–	Install main frame for flap modules → Chapter and → Chapter. -12-

–	Check trim height -B- and adjust again, if necessary.

–	Install side trim panel → Chapter.

Volkswagen Workshop Service and Repair Manuals