volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Adjusting camber on rear axle > < Overview - wheel alignment procedure

New Beetle

Adjusting camber at front wheels
Adjusting camber at front wheels
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1332-
If a value lies outside the tolerances, the vehicle's transverse inclination must be checked and compensated if necessary, → Chapter.
Only by moving the subframe is it possible to adjust the camber evenly within the tolerance range.
  W00-0428
–  Loosen bolts -1- and -2-.
–  Move subframe until camber is the same on both sides.
–  Then check caster.
The caster can change when moving the subframe.
–  Secure subframe with new bolts.
  N44-0084
Specified torques: 
Subframe to body
Bolt position -1-
Use new bolts!		100 Nm + 90°
Subframe to body
Bolt position -2-
Use new bolts!		100 Nm + 90°

   

Adjusting camber on rear axle > < Overview - wheel alignment procedure