volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Vehicle data sticker > < Test preparations

New Beetle

Transverse vehicle inclination “zero position”
Transverse vehicle inclination “zero position”
In general:
If a value lies outside the tolerance, the vehicle's transverse inclination must be checked first, but this is otherwise not necessary.
If measured values are outside permitted tolerances, this may be because the vehicle is inclined.
Right-hand drive vehicles or for, example vehicles, with an automatic gearbox may lean to one side slightly.
This is due to the installation position of the assemblies and their associated weight transfer and is normal.
   
–  In such cases it is essential to measure dimension -a- at the rear on both sides.
The 0-line on the roof symbolises the horizontal position (zero position) of the vehicle.
–  Correct any differences as required.
On the front axle, compensate by adding weights to the top of the respective suspension turret.
On the rear axle, compensate by adding weights to the respective side of the luggage compartment.
Sand-filled sacks (weighing approx. 10 kg) are suitable for this.
  N44-0057

Vehicle data sticker > < Test preparations