New Beetle L4-1.8L Turbo (AWP) (2003)
/Page-1713002.png)
follows:
^
Prior to starting procedure, protect interior from metal shavings and chips.
-
Partially open convertible top (approx. 1/3 open).
-
Locate outermost trim attachment slots (arrow indicates right side) at metal frame (left and right).
^
Procedure must be performed on left and right sides.
Extend slot as follows:
-
Locate the centerline of the slot.
-
Measure inboard, 17.9 mm from inboard radius of the existing slot.
-
Mark this location.
-
Drill a 5 mm hole -A- at this location.
-
Scribe top and bottom edges of slot to the hole (this will be the material to be removed).
-
Mark and drill three additional holes approx. 3.5 mm in diameter between the edge of the existing slot and the 5 mm hole as shown
