New Beetle L4-1.8L Turbo (AWP) (2003)
Oil Pan: Service and Repair
Oil pan, removing and installing
Special tools and equipment
^
3185 Extension socket wrench
^
3249 Socket
^
VAG1331 Torque wrench (5 to 50 Nm)
^
Silicone sealant D 176 404 A2
^
Hand drill with plastic brush
^
Protective glasses
^
Flat scraper
Removing
-
Removing center and right insulation tray:
-
Drain engine oil.
Note: Observe disposal regulations!
-
Detach turbocharger oil return pipe from oil pan.
-
Loosen oil pan bolts using extension socket wrench 3185. Unscrew with socket 3249.
-
Remove oil pan; it may be necessary to release oil pan by tapping lightly with a rubber head hammer.
-
Remove sealant residue on cylinder block with a flat scraper.
-
Remove sealant residue on oil pan with a rotating brush, e.g. a hand drill with a plastic brush (wear protective glasses).
-
Clean sealing surface; it must be free of oil and grease.
Installing