New Beetle L4-1.8L Turbo (AWP) (2003)
/Page-262003.png)
-
Block tensioner with 3090.
-
Remove ribbed belt.
Installing
CAUTION:
-
When installing ribbed belts that have already been used, please make sure to mark the running direction during removal!
-
Before installing the ribbed belt, make sure that all subassemblies (generator, a/c compressor etc.) are securely mounted and turn freely.
-
When installing belt, ensure correct seating in the belt pulleys!
-
Install ribbed belt according to routing diagram.
-
Counter-hold tensioner and remove 3090.
-
Slowly release tensioner to engage ribbed belt.
-
Start engine and check belt running.
-
Install engine cover.
-
Install center and right (lower) engine covers (noise insulation).
