volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

With Manufacturer's Scan Tool|Page 3595 > < With Manufacturer's Scan Tool|Page 3593
Page 3
background image

-

Pull vacuum hose -1- off fuel pressure regulator -2-.
Fuel pressure must increase to approx. 3.0 bar.

-

Switch off ignition.

If the specification is not obtained:

-

Check quantity supplied by fuel pump.

If the specification is obtained:

-

Switch off ignition.

-

Check for leaks and holding pressure by observing pressure drop on gauge.
After 10 minutes there must be a residual pressure of at least 2.0 bar.

If the holding pressure drops below 2 bar:

-

Start engine and run at idle speed.

-

Switch ignition off after pressure has built-up. At same time close pressure measured device cut-off tap (handle cross through-flow direction
-arrow-).

-

Observe pressure drop on gauge.

If the pressure does not drop:

-

Check fuel pump non-return valve.

If the pressure drops again:

With Manufacturer's Scan Tool|Page 3595 > < With Manufacturer's Scan Tool|Page 3593