New Beetle L4-1.8L Turbo (AWP) (2003)
-
Check wires between test box and 6-pin connector for open circuit according to wiring diagram:
Terminal 1 + socket 92
Terminal 2 + socket 83
Terminal 3 + socket 117
Terminal 4 + socket 84
Terminal 5 + socket 118
Terminal 6 + socket 91
Wire resistance: max. 1.5 ohms
-
Also check wires for short circuit to each other.
Specified value: Infinite Ohms
If no malfunctions are found in wires:
-
Check voltage supply of Engine Control Module ECM). See: Engine Control Module/Testing and Inspection/ECM Voltage Supply, Checking
-
Erase DTC memory of Engine Control Module ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes