New Beetle L4-1.8L Turbo (AWP) (2003)
/Page-172003.png)
-
Disconnect 2-pin connector -arrow- from Intake Air Temperature (IAT) sensor -G42-.
-
Remove Intake Air Temperature (IAT) sensor -arrow-.
-
Re-connect 2-pin connector.
-
Note intake air temperature value in display zone 4.
-
Spray sensor -arrow- with commercial chilling agent while observing temperature value.
Temperature value must decrease.
If the specification is not obtained:
-
Press -> button.
-
Press buttons -0- and -6- for function "End output" and confirm entry with -Q- button.
-
Switch off ignition.
