New Beetle L4-1.8L Turbo (AWP) (2003)
Oil seal for right flanged shaft, replacing
Special tools and equipment
^
3158 Drift sleeve
^
V.A.G. 1331 Torque wrench or equivalent
^
V.A.G. 1332 Torque wrench or equivalent
Removing
^
If installed, remove center and right part of insulation tray below engine/transmission.
^
Turn steering to right onto full lock stop.
^
Remove drive shaft.
^
Remove flanged shaft securing bolts by threading two bolts into flange and counterhold flanged shaft using a lever.
^
Place container under transmission
^
Remove flanged shaft with spring.
^
Pry seal out.