New Beetle L4-1.8L Turbo (AWV) (2005)
/Page-1034001.png)
Engine Control Module: Service and Repair
Engine Control Module (ECM), Replacing
Engine Control Module (ECM), Replacing
Work procedure
Check control module identification of the previous Engine Control Module (ECM) as follows:
-
Connect diagnostic tester.
-
Switch ignition on.
-
Under address word 33, select "Diagnostic mode 9: Vehicle information".
-
Select the vehicle information "Test-ID 04: Calibration Identification".
Control module identification will be displayed, e.g.:
06A906032 LS 4745
-
End diagnosis and switch ignition off.
-
Remove inner cover, left plenum chamber, to do this, slide center cover -1- of plenum chamber forward out of catch and remove from instrument
panel.
-
Remove three bolts -1-.
