New Beetle L4-1.8L Turbo (AWV) (2005)
If specified value is not obtained:
-
Replace respective knock sensor:
-
Knock Sensor (KS) 1 -G61-.
-
Knock Sensor (KS) 2 -G66-.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check wires to control module according to wiring diagram.
Check wires to control module
-
Connect test box to control module wiring harness. connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
-
Check wires between test box and 2-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Wire resistance: max. 1.5 Ohms
-
Check wires for short circuit to each other.
Specified value: Infinite Ohms
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
Test procedure (Vehicles with engine code AWP, AWV, BKF, BNU)