New Beetle L4-1.8L Turbo (AWV) (2005)
-
End diagnosis and switch ignition off.
Continuation of test if indication is approx. -40 degrees C:
-
Disconnect 4-pin connector from Engine Coolant Temperature (ECT) Sensor -G62- with Engine Coolant Temperature (ECT) Sensor -G2- (arrow).
-
Bridge terminals 3 + 4 of connector using the respective adapter cables and observe the indication on display.
If indication jumps to approx. 143 degrees C:
-
End diagnosis and switch ignition off.
-
Replace Engine Coolant Temperature (ECT) Sensor -G62- with Engine Coolant Temperature (ECT) Sensor -G2-
WARNING:
-
The cooling system is under pressure.
-
Danger of scalding when opening.
-
Erase DTC memory of Engine Control Module (ECM). Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If indication remains at approx. -40 degrees C:
-
End diagnosis and switch ignition off.
-
Check wires to control module according to wiring diagram.
Continuation of test if indication is approx. 143 degrees C: