New Beetle L4-1.8L Turbo (AWV) (2005)
Oxygen Sensor: Testing and Inspection
Oxygen Sensor and Oxygen Sensor Control Before Catalytic Converter, Checking
Oxygen Sensor And Oxygen Sensor Control Before Catalytic Converter, Checking
NOTE:
-
Vehicle must be raised before the oxygen sensor connector is accessible.
-
When servicing terminals in harness connector of oxygen sensor, use only gold-plated terminals.
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Test requirements
-
The respective fuses of Heated Oxygen Sensor (HO2S) -G39- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers such as: lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else day time driving lights will be switched on.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
For vehicles with automatic transmission, selector lever must be in -P-.
-
Ground (GND) connections between engine and chassis must be OK.
-
Exhaust system must be properly sealed between catalytic converter and cylinder head.
-
Coolant temperature must be at least 80 degrees C. Diagnostic mode 1: Check measured values; PID 5, Coolant temperature. See: Testing and
Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measured Values
-
Oxygen sensor heater for oxygen sensor before catalytic converter must be OK, check. See: Oxygen Sensor Heater For Oxygen Sensor Before
Three Way Catalytic Converter (TWC), Checking
Function test
-
Select the following output of oxygen sensor signals and check whether the specified values are being reached. Diagnostic mode 5: Check output
of oxygen sensor signals. See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 5: Check
Output of Oxygen Sensor Signals
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
Check oxygen sensor wires to control module according to wiring diagram.
Checking oxygen sensor wires to control module