New Beetle L4-1.8L Turbo (AWV) (2005)
15. Cover for fuel tank
16. 20 Nm plus an additional 90 degrees (1/4 turn)
-
Always replace
17. Tension strap
-
Note varying lengths
-
Installation position: Locating point (hole) faces direction of travel
18. Fuel filter
-
Installation position: Arrow points in direction of flow
19. Screw clamp
-
Note installed position, see below Fig. 4
20. Supply line
-
Black
-
Check for secure seating
-
To remove from fuel filter, press release buttons on connecting piece
-
To fuel supply line at fuel distributor.
21. Ventilation line
-
White
-
Check for secure seating
-
Clipped in at top of fuel tank
-
To Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-.
22. Seal
-
Replace if damaged
-
To install, place into opening of fuel tank when dry
-
Only coat with fuel when installing Fuel Pump (FP) flange
23. Fuel pump (FP) unit
-
Note installation position of flange at fuel tank, see below Fig. 1.
-
Checking Fuel Pump (FP).
-
Clean strainer if dirty
24. Union nut, 75 Nm
-
Use wrench 3217 to remove and install
25. Supply line
-
Black
-
Check for secure seating
-
Clipped in sideways at fuel tank
-
To remove from flange and fuel filter, press release buttons on connecting piece
26. Return line
-
Blue or with blue marking
-
Clipped in sideways at fuel tank
-
Check for secure seating
-
To remove from flange, press release buttons on connecting piece
-
From fuel return line at fuel distributor.
27. Gravity valve
-
To remove, unclip valve upward from connection
-
Checking valve for throughput Valve vertical: open, Valve tilted 45 degrees: closed
28. Pressure retention valve
-
For fuel tank ventilation
-
Checking, see below Fig. 3
29. Ground (GND) connection
-
Check for secure seating
Fig. 1 Installation position of Fuel Pump (FP) flange