New Beetle L4-1.8L Turbo (AWV) (2005)
/Page-391002.png)
-
Disconnect connector from Multi-Function Transmission Range (TR) Switch -F125-
-
Remove mounting bolt and retainer.
-
Remove Multi-Function Transmission Range (TR) Switch.
-
Replace O-ring.
Installation is in reverse order of removal.
-
Tighten bolt to 10 Nm.
-
Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic
Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
Work sequence (vehicles with 09G transmission)
-
Remove air filter housing.
-
Pry off selector lever cable -1- from lever -4- using an open-end wrench 10 mm -3-
-
Compress locking mechanism (arrows) and pull selector lever cable out of mounting bracket.
-
Disconnect connector -2- from Multi-Function Transmission Range (TR) Switch -F125-