New Beetle L4-1.8L Turbo (BNU) (2005)
Control Assembly: Service and Repair
Heating and Ventilation Cables, Installing and Adjusting
Heating and Ventilation Cables, Installing and Adjusting
NOTE:
-
Cable sleeve ends are color coded.
-
Check cables before installing. Replace binding or damaged cables.
-
Attach cables to removed controls first and then attach to levers at heating and ventilation unit.
-
All air flaps must audibly move onto end stops when turning controls.
1. Central flap cable
-
From air distribution rotary control to central flap
-
Cable sleeve marking: Yellow
-
Installing and adjusting See Fig. 3
2. Footwell/defrost flap cable
-
From air distribution rotary control to footwell/defrost flap
-
Cable sleeve marking: Green
-
Removing:
-
Remove heating and ventilation controls
-
Unclip cable from controls
-
Remove steering column trim.
-
Unclip cable at heating and ventilation unit.
-
Installing and adjusting See Fig. 2
3. Heating and ventilation controls
4. Temperature flap cable
-
From temperature rotary control to temperature flap
-
Cable sleeve marking: Beige
-
Installing and adjusting See Fig. 1
Fig. 1 Temperature flap cable, installing and adjusting