New Beetle L4-1.8L Turbo (BNU) (2005)
/Page-1858003.png)
-
Remove parking brake cable from holders - arrow B -.
-
Place Engine/transmission jack V.A.G 1383 A underneath.
-
Remove mounting bracket bolt - 1 - at rear axle on both sides.
Vehicles in which point of bolt - 2 - points toward vehicle exterior (only valid for right side of vehicle):
-
Loosen bolt - 2 - and remove nut.
-
Mark installation position of mounting bracket for rear axle and remove mounting bracket from chassis.
-
Pull bolt - 2 - out of mounting bracket.
Continued for all vehicles
-
Lower rear axle using Engine/transmission jack V.A.G 1383 A.
-
Secure rear axle using tensioning belt T10038 over exhaust system suspension.
Vehicles with automatic headlight range control
-
Remove coupling rod of Left Rear Level Control System Sensor G76 from rear axle.
Continued for all vehicles
CAUTION: Place engine/transmission jack V.A.G 1383 A with universal transmission support V.A.G 1359/2 under control arm (danger of accident
from components falling out when pulling out bushing).
Pressing out core of hydraulic bonded rubber bushing
-
Attach special tools as shown in illustration on to rear axle.
-
Pull a plastic bag over special tools and control arm so that escaping oil can be caught when pressing out.
-
Press out core of bonded rubber bushing.
1. VAS 6178
