New Beetle L4-1.8L Turbo (BNU) (2005)
11. Lever for gear selector rod
12. Support bracket
^
For selector lever cable to transmission
13. Bolt, 23 Nm
^
For support mounting
^
Qty. 2
14. Nut, 8 ± 0.8 Nm
15. Bracket
^
With clip for selector lever cable
Removing
-
Check whether a coded radio is installed. If so, obtain anti-theft coding.
-
Move selector lever to position "R".
-
With ignition switched off disconnect battery Ground strap.
-
Remove selector lever handle.
-
Remove selector mechanism and printed circuit board cover.
-
Carefully pry frame up at four corners - arrows - and remove.
-
Disconnect connector - arrow - from Shift lock solenoid -N110-.
-
Move pull rod upward and shift selector lever to position "P" with pull rod still held up.
-
Unhook locking cable - 1 - from selector mechanism locking lever.
-
Remove forward mounting for selector mechanism (2 nuts) - arrows -.