New Beetle L4-1.8L Turbo (BNU) (2005)
Note: If a connection is damaged, replace the wiring harnesses or the valve body with solenoid valves.
-
Disconnect connector - 2 - from transmission connector.
-
Remove bolt/screw securing 14-pin transmission connector.
-
Pull connector and wiring out of transmission housing.
Installing
Installation is performed in the reverse sequence of removal. In the process, note the following:
-
Replace O-ring on connector.
-
Push connector with new O-ring into transmission up to limit stop.
-
Tighten bolt for 14-pin transmission connector.
-
Tighten retainer bolts for speed sensor connections.
-
Tighten bolt for Transmission fluid temperature sensor -G93- retainer to 11 Nm.
-
Install oil strainer.
-
Install oil pan.