New Beetle L4-1.8L Turbo (BNU) (2005)
Valve Body: Service and Repair
Wiring Harness With 8-Pin Connector, Removing and Installing
Wiring harness with 8-pin connector, removing and installing, 09G, 6 Spd. A/T
Removing
-
Remove oil pan.
-
Remove oil strainer.
-
Disconnect connectors of hydraulic pressure sensors - 1 - and - 4 -.
-
Disconnect connectors - 2 - and - 5 -.
Note: If a connection is damaged, replace the wiring harnesses, the Transmission input speed (RPM) sensor -G182- or the Transmission output speed
(RPM) sensor -G195-.
-
Remove bolt - 6 -.