New Beetle L4-1.8L Turbo (BNU) (2005)
-
Pull locking pin -A- back to original position (direction of arrow).
-
Pull pin T10027 out of holes -A- and -B-.
-
Clip cover into frame.
Functional check
-
Gear shift lever must rest in 3rd/4th gear gate with transmission in neutral.
-
Operate clutch.
-
Select all gears several times. Pay particular attention to operation of reverse gear lock.
-
Should a gear fail to engage smoothly after repeated selection of 1st, 2nd, 5th or 6th gear, check the following:
-
Carefully guide gear shift lever in neutral to left into gate for 1st/2nd gear.
-
Selector shaft must move downward (arrow -1-).
-
To check if shift mechanism is correctly adjusted, have second technician attempt to push locking pin -A- into transmission (direction of arrow)
and thus into selector shaft gate.
-
If this cannot be accomplished:
-
Adjust selector mechanism.