New Beetle L4-1.9L DSL Turbo (BEW) (2006)
-
Start the engine and let it run at idle.
-
Using a multimeter, check the Mass Air Flow (MAF) Sensor (G70) electrical harness connector terminal 2 to engine Ground (GND).
Specified value: battery voltage.
-
Switch the ignition off.
If specified value was not obtained:
-
Check the Mass Air Flow (MAF) Sensor (G70) electrical harness connector terminal 2 to the Power Supply Relay (terminal 30, B+) (J317)
terminal 6/87 for an open circuit.
Specified value: 1.5 ohms max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
Checking 5 volt reference
-
Start the engine and let it run at idle.
-
Using a multimeter, check the Mass Air Flow (MAF) Sensor (G70) electrical harness connector terminal 3 to engine Ground (GND).