New Beetle L4-1.9L DSL Turbo (BEW) (2006)
/Page-1202002.png)
-
Remove mounting bolts (arrows) from transmission holder.
-
Remove mounting bolts (arrows) for pendulum support and remove pendulum support.
-
Lower transmission approx. 60 mm -dimension a-.
-
Remove mounting bolt and remove sensor -1- from transmission.
-
Disconnect harness connector from Vehicle Speed Sensor (VSS) -G68-.
Installation is performed in reverse order of removal.
-
Replace O-ring.
-
Install sensor and tighten to 10 Nm.
Tightening torques of transmission holder and of pendulum support: transmission, removing and installing
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code.
