New Beetle L4-1.9L DSL Turbo (BEW) (2006)
Shift Interlock Cable: Adjustments
Locking cable, adjusting, 02E, 6 Speed Direct Shift A/T
Special tools, testers and auxiliary items required
^
Adjustment Pin For Shift-lock 3 3352 A
CAUTION: Locking cable adjustment must always be performed as described in the following.
Adjustment requirements:
^
Locking cable in installation position
^
Center console removed.
^
Selector lever in position "P".
^
Ignition key in removal position.
Adjusting procedure:
^
Steering column is located in rear/bottom position.
-
Loosen bolt - 1 - on mounting bracket.
-
Attach Adjustment Pin For Shift-lock 3 3352 A between locking lever - 2 - and locking eyelet - 3 -.
-
To compensate for play, pull mounting bracket in direction of - arrow - until it stops.
-
It must be possible to easily remove and insert Adjustment Pin For Shift-lock 3 3352 A in this position.
-
Tighten bolt - 1 - at mounting bracket to 10 Nm.
-
Remove adjusting gauge.
-
Now the function of ignition key removal lock must be checked.