New Beetle L4-1.9L DSL Turbo (BEW) (2006)
/Page-1586002.png)
-
Using a multimeter, check the Transmission Fluid Temperature Sensor (G93) terminals 1 to 12 for resistance.
If any of the specified values are not obtained:
-
Replace the Transmission Fluid Temperature Sensor (G93).
If the specified values are obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box. Refer to => [ 68 Pin Test Box Adapter, Installing ] See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/68 Pin Test Box Adapter, Installing.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Transmission Control Module (TCM) ( J217). => [ Transmission Control Module, Replacing ] See: Control Module/Service and
Repair/Transmission Control Module, Replacing.
-
Using a multimeter, check the Transmission Fluid Temperature Sensor (G93) electrical harness connector terminals to the Transmission Control
Module (TCM) (J217 ) electrical harness connector T68 terminals for an open circuit.
