New Beetle L4-1.9L DSL Turbo (BEW) (2006)
/Page-1587001.png)
Transmission Temperature Sensor/Switch: Service and Repair
Transmission Input Speed Sensor with Clutch Oil Temperature Sensor
Removing
‹› Both sensors are combined into one component and can only be replaced together. They are located in transmission in vicinity of clutch. Before
removing, Direct Shift Gearbox (DSG) Mechatronic ( J743) must be removed.
CAUTION!
Do not pull on wire of connector! If wire is damaged, the Transmission Input Speed (RPM) Sensor ( G182) with Clutch Oil Temperature
Sensor (G509) must be replaced.
-
Remove Direct Shift Gearbox (DSG) Mechatronic ( J743 ) => [ Direct Shift Gearbox Mechatronic ] See: Service and Repair/Removal and
Replacement/02E Transmission/Direct Shift Gearbox Mechatronic.
Do not pull on wire!
-
Remove bolt - B - and carefully pry out sensor - A - using a screwdriver and/or pliers.
-
Carefully disconnect connector - C -.
Installing
Re-install Transmission Input Speed (RPM) Sensor ( G182 ) with Clutch Oil Temperature Sensor (G509 ) only if it is certainly known:
‹› Sensor functions properly.
‹› Its wire was not pulled during removal.
-
If necessary, clean bore for Transmission Input Speed (RPM) Sensor (G182) with Clutch Oil Temperature Sensor (G509) of sealant residue.
-
Coat new Transmission Input Speed (RPM) Sensor ( G182) with Clutch Oil Temperature Sensor (G509 ) - A - with direct shift transmission oil
and guide sideways into opening on transmission housing.
