New Beetle L4-1.9L DSL Turbo (BEW) (2006)
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Diesel Direct Fuel Injection (DFI) Engine Control Module (ECM) (J248). Refer to => [ Engine Control Module, Replacing ] See:
Powertrain Management/Computers and Control Systems/Engine Control Module/Service and Repair/Engine Control Module, Replacing.
-
Assembly is performed in the reverse of the removal.
Final procedures
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) (J217). => [ Diagnostic Mode 04 - Erase DTC Memory ] See:
Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase
DTC Memory.
3. Generate readiness code. => [ Readiness Code ] See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors,
Trips, Drive Cycles and Readiness Codes/Readiness Code.