New Beetle L4-2.0L (AVH) (2005)
-
Unclip push rod -2-.
-
Open trim -4-.
-
Loosen bolts/screws -1-.
-
Align flap module -3- in direction of -arrows- using a screwdriver -5-.
-
Tighten screws/bolts -1- (3 Nm).
-
Close trim -4-.
-
Clip in push rod -2-.
-
Check slack -B- 3.5...4.5 mm and adjust if necessary.
-
Install side panel trim.
Adjusting slack C and D
-
Remove side panel trim.
-
Remove bolts/screws -1-.
-
Align flap module -2- in direction of -arrows-.
-
Tighten screws/bolts -1- (3 Nm).