New Beetle L4-2.0L (AVH) (2005)
Headlamp Alignment Actuator: Service and Repair
Headlight Beam Adjusting Motor -V48- / -V49-, Removing and Installing
Removing
-
Remove headlight housing.
-
Remove sealing cap.
-
Remove screws -arrows- on motor.
-
Pull positioning rod ball head out from locking device on reflector.
-
Disconnect electrical connection.
Installing
Installation in reverse sequence or removal.
-
Check headlight function.
-
Perform headlight basic setting (function 04) using On Board Diagnostic program.