New Beetle L4-2.0L (AVH) (2005)
Brake Light Switch: Service and Repair
"Old Style" Brake Light Switch, Removing and Installing/Adjusting
"Old style" Brake light switch, removing and installing/adjusting
Note:
^
The following applies only to an existing, functional "Old style" switch that is removed and reinstalled/adjusted.
Removing
-
Disconnect connector from Brake light switch.
-
Remove Brake light switch by turning counter-clockwise 90°.
-
Pull switch out from retainer mounting hole.
Installing/adjusting
-
Before installing, pull out plunger completely.
-
Apply a light coat of lubricant G 052 142 A2 to end of plunger.
-
Depress and hold brake pedal in down position.
-
Note orientation of retainer tabs on switch and carefully insert switch into retainer mounting hole
-
Secure Brake light switch by turning clockwise 90°.
-
Slowly release brake pedal to stop.
Note:
^
The above action automatically adjusts the switch plunger travel.
-
Connect connector for Brake light switch.
-
Check functioning of brake light.