New Beetle L4-2.0L (AVH) (2005)
/Page-962005.png)
-
Ground (GND) connections between engine and chassis must be OK.
-
Throttle valve must not be damaged or dirty.
-
Coolant temperature must be at least 80 degrees C. Diagnostic mode 1: Check measured values; PID 5, Coolant temperature. See: Testing and
Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measured Values
Function test
-
Connect diagnostic tester. See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Diagnostic Tester,
Connecting
-
Switch ignition on.
-
Under address word 33, select "Diagnostic mode 1: Check measured values."
-
Select measuring value "PID 17: Throttle valve position (absolute)."
-
Check specified value of throttle valve position (absolute) at idle stop:
-
Slowly depress accelerator pedal to Wide Open Throttle (WOT) stop while observing percentage display.
The percentage display must increase uniformly.
-
Check specified value of throttle valve position (absolute) at Wide Open Throttle (WOT) stop:
-
End diagnosis and switch ignition off.
If specified values are not obtained:
-
Disconnect 6-pin connector (arrow) at throttle valve control module.
Checking resistance
