New Beetle L4-2.0L (AVH) (2005)
Information Bus: Testing and Inspection
Terminal Resistance For CAN-Bus (vehicles With Engine Code AVH, AZG, BDC, BEV, BGD), Checking
Function
The Engine Control Module (ECM) communicates with all databus-capable control modules via a CAN databus.
These databus-capable control modules are connected via two data bus wires which are twisted together (CAN_High and CAN_Low), and exchange
information (messages). Missing information on the databus is recognized as a malfunction and stored.
Trouble-free operation of the CAN-Bus requires that it have a terminal resistance. This central terminal resistor is located in the Engine Control Module
(ECM).
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
-
Ignition switched off.
Work sequence
-
Connect test box to Engine Control Module (ECM). connect test box for wiring test. See: Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test During this, wiring harness to Engine Control Module (ECM) is not
connected.
-
Check central termination resistor in the Engine Control Module (ECM):
-
To do this, measure resistance between test box socket 58 + 60:
Specified value: 60 to 72 Ohms
If resistance value is not in specified range:
-
Replace Motronic Engine Control Module (ECM) -J220-.
If resistance value is in specified range:
-
Disconnect test box from Engine Control Module (ECM).
-
Connect test box to control module wiring harness.
-
Check CAN data bus wires for shorts among one another:
-
To do this, perform a resistance measurement between test box sockets 58 + 60:
Specified value: Infinite Ohms
If specified value is obtained (wires have no shorts):
-
Eliminate error in wires (see circuit diagram).