New Beetle L4-2.0L (AVH) (2005)
Camshaft Position Sensor: Testing and Inspection
Camshaft Position (CMP) Sensor, Checking
NOTE: Use only gold-plated terminals when servicing terminals in harness connector of sensors.
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Requirements
-
The respective fuses of Motronic Engine Control Module (ECM) -J220- must be OK.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers such as, lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
Ground (GND) connections between engine and chassis must be OK.
Work sequence (Vehicles with engine code AVH, AZG, BDC, BEV, BGD)
-
Disconnect 3-pin connector from Camshaft Position (CMP) sensor (arrow).