New Beetle L4-2.0L (AVH) (2005)
-
Remove ATF control plug - arrow 1 - when ATF temperature reaches 35°C.
-
Always replace the seal - arrow - for the ATF control plug.
-
ATF present in the overflow pipe - arrow2 - will drain out first.
-
If ATF continues to leak out of the ATF control pipe opening before the ATF temperature has reached 40°C, the ATF level is OK.
-
Tighten ATF control plug - arrow 1 - (with a new seal) to 27 Nm. ATF check is now completed.
Note: Reinstall the ATF control plug at the latest before the temperature reaches 45°C (50°C for hot climates).
If no ATF leaks out before ATF temperature reaches 45°C, top up. Go to ATF level, topping up. See: Service and Repair/09G, 6 SPD. A/T/ATF
Level, Topping Up
-
End function "08 - Read measured value data block" by touching key.
-
Press on function "06 - End output".
-
Switch off ignition and disconnect diagnosis cable.